Garage Door Repair North Richland Hills TX to counterbalance their weight and make them easy to open and close. These springs work in tandem with cables to ensure smooth and controlled movement.
When it comes to installing or replacing garage door springs and cables, safety should be your top priority. If you are not confident in your ability to do this job safely, it is best to hire a professional.
Before You Begin
- Gather Your Tools and Materials: You will need a set of winding bars, vise grips, a ladder, safety glasses, gloves, a tape measure, a level, and the replacement springs and cables that match your garage door’s specifications.
- Disconnect the Power: Unplug the garage door opener from the electrical outlet or turn off the circuit breaker that powers it.
- Secure the Door: Ensure the garage door is fully closed and locked in place. This prevents it from accidentally falling while you work on the springs.
Removing the Old Springs and Cables
- Locate the Springs: Garage door springs are usually located above the door, either on a torsion bar (torsion springs) or on the sides of the door (extension springs). Identify which type of springs you have.
- Release Tension: If you have torsion springs, use vise grips to secure the torsion bar on one side of the door to prevent it from turning. Then, using winding bars, release tension from the springs by turning them counterclockwise. Be extremely cautious, as releasing tension can be dangerous.
- Remove the Cables: Disconnect the old cables from the bottom brackets and the pulleys. Note how they are attached so you can reinstall the new cables correctly.
- Remove the Springs: Once the tension is released, carefully remove the old springs. Dispose of them properly.
Installing New Springs and Cables
- Determine the Correct Springs: Consult your garage door’s manual or the manufacturer’s instructions to ensure you are using the correct springs and cables for your door’s weight and size.
- Install the New Springs: Slide the new torsion springs onto the torsion bar. Make sure they are evenly spaced and secure. Using the winding bars, wind the springs by turning them clockwise. Follow the manufacturer’s guidelines for the number of turns required to achieve the correct tension.
- Attach the Cables: Thread the new cables through the pulleys and reattach them to the bottom brackets. Ensure they are properly seated and secure.
- Check the Balance: Carefully raise the door by hand to check its balance. It should stay in place when you release it at any point along its travel. If the door is unbalanced, you may need to adjust the spring tension.
- Adjust the Spring Tension: If the door is not balanced, use the winding bars to adjust the spring tension. Add or remove turns as needed, making small adjustments until the door is properly balanced.
- Test the Door: With the power still disconnected, manually open and close the door to ensure it operates smoothly and without any issues.
Final Steps
- Reconnect the Power: Once you are confident that the door is functioning correctly, plug in the garage door opener or turn the circuit breaker back on.
- Test with the Opener: Test the garage door opener to make sure it works as expected. Observe the door’s movement to ensure it is not jerky or unsteady.
- Regular Maintenance: Garage door springs and cables require regular maintenance to ensure they continue to function correctly. Lubricate them with garage door lubricant as recommended by the manufacturer.
- Safety First: Always exercise caution when working with garage door springs and cables. If you are unsure about any step in the process or encounter difficulties, seek professional assistance.
Remember that Garage Door Repair North Richland Hills TX installation can be extremely hazardous. The springs store a significant amount of energy, and mishandling them can lead to serious injury or even death. If you have any doubts about your ability to perform this task safely and correctly, it is highly recommended that you hire a qualified garage door technician. Your safety should always be the top priority.
NRH’s Gates & Garage Doors
7048 Ridge Crest Dr, North Richland Hills, TX 76182, United States
1-817-533-4913