Fixing a garage door spring can be a daunting task, but with the right tools and knowledge, it can be done safely and efficiently. Garage Door Repair Wise County TX springs are responsible for counterbalancing the weight of the door, making it easier to open and close.

There are two types of garage door springs: Torsion and Extension.

Torsion springs are mounted above the door and are wound tightly to store energy, while extension springs are mounted on either side of the door and extend when the door is opened.

Before attempting to fix a garage door spring, it is important to take proper safety precautions. Garage door springs are under a lot of tension and can be dangerous if they are not handled properly.

Follow these steps to fix a Garage Door Repair Wise County TX spring safely and efficiently:

Step 1: Identify the Problem

The first step in fixing a garage door spring is to identify the problem. If the door is not opening or closing properly, the spring may be broken or damaged. If you hear a loud bang when the door is opening or closing, the spring may have snapped. It is important to inspect the spring to determine the extent of the damage.

Step 2: Gather the Necessary Tools

To fix a garage door spring, you will need the following tools:

  • Winding bars
  • Socket wrench
  • Safety glasses
  • Leather gloves
  • Ladder
  • Tape measure
  • Replacement spring (if necessary)

Step 3: Release the Tension on the Spring

Before attempting to fix a garage door spring, you must release the tension on the spring. This can be done by placing a winding bar into the winding cone on the spring and turning it counterclockwise until the tension is released. Be sure to keep a firm grip on the winding bar and keep your face and body away from the spring.

Step 4: Remove the Old Spring

Once the tension is released, you can remove the old spring. Use a socket wrench to loosen the bolts on the stationary cone and slide the cone off the shaft. Slide the old spring off the shaft and remove it from the garage door.

Step 5: Measure the New Spring

Before installing a new spring, you must measure the old spring to determine the correct size replacement. Measure the length of the spring, the inside diameter, and the wire size.

Step 6: Install the New Spring

Install the new spring by sliding it onto the shaft and positioning it in place. Slide the stationary cone onto the shaft and tighten the bolts with a socket wrench. Use a winding bar to wind the spring clockwise until it reaches the appropriate tension.

Step 7: Test the Door

Once the new spring is installed, test the door to ensure it is opening and closing properly. If the door is still not functioning correctly, you may need to adjust the tension on the spring.

Step 8: Make Adjustments

If the door is not opening and closing properly, you may need to adjust the tension on the spring. This can be done by winding the spring either tighter or looser with the winding bars. Be sure to make small adjustments and test the door after each adjustment.

Step 9: Secure the Spring

Once the tension is adjusted to the correct level, secure the spring by tightening the bolts on the stationary cone with a socket wrench.

Step 10: Perform Regular Maintenance

To ensure your garage door springs continue to function properly, it is important to perform regular maintenance. This includes lubricating the springs and rollers and inspecting the door for any signs of wear or damage.

In conclusion, fixing a garage door spring can be a challenging task, but with the right tools and knowledge, it can be done safely and efficiently. Remember to take proper safety precautions and follow the steps outlined above to fix your garage door spring.

Wise County Door and Gate

1-940-304-0821