Ghostbusters may be called if your garage doors start opening on their own. Ghostly things or more rational considerations: You need to quickly find out the cause of your garage door opening by itself. You could be open for theft or damage from potential intruders.

Based on a survey that was conducted by Garage Door Repair Rockwall TX. A mistake by you, or your last family member using the garage, is one of the most common causes. This is especially true if they are in a rush. You can’t make it close if you push the remote while driving away. It’s the first thing you should check.

Next, make sure to inspect the safety sensors. These sensors are intended to prevent the door from closing in reverse if it is blocked by anything. Verify that there is no debris, ice, or snow on the door. Sometimes, one or more sensors can become misaligned. In this case, the sensors will need to replace.

Another common problem is that the buttons on your remote or wall opener are stuck. Make sure to clean them and check the wiring.

You can also check the control wiring. This wire runs from your opener’s motor unit, located in the middle of the ceiling tracks, to the control button mounted on a wall. The garage door may not open due to a short circuit, or a bare spot.

A garage door that doesn’t close can pose a threat to your garage’s security and expose it to the elements.

We have already covered the safety sensors and how they work to open the garage door if there is an object in its path. The garage door could not close if one of the photo sensors is dirty or if it isn’t in line. You should also check that the wires are connected properly. Use a tissue to clean the sensors and align them. Finally, check the wiring.

Broken torsion springs allow your garage doors open and close. The sound of a spring breaking is likely to be the reason your garage door won’t close. Torsion springs will always break when the door is closed. Snapped cables are another example; these will be obvious; they often snap when spring breaks. These jobs can be done by someone who has the right tools and knowledge.

Garage doors can’t close if the tracks become blocked or damaged. It is best to remove the blockage as soon as possible. You will need to replace the track if it is bent or warped.

Lastly, according to Garage Door Repair Rockwall TX, limit settings default when a garage door opener has been installed. These settings may change over time. Garage doors will stop when they reach the ground. If it hits an object, the garage door will go in reverse. The garage door opener manual will have the details. You can adjust the settings according to the instructions.

Rockwall Best Garage & Overhead Doors

Rockwall, Texas 75087

469-423-8082