To program the Garage Door Repair Keller TX opener for a Kia Sorento, follow the steps below. Please note that the exact instructions may vary depending on the model year and trim level of your Sorento.

It’s always a good idea to consult the owner’s manual for your specific vehicle for accurate instructions.

  1. Clear any previously programmed codes: Before programming a new code, it’s important to clear any existing codes from the garage door opener’s memory. Locate the garage door opener’s “learn” button, usually located on the motor unit. Press and hold this button until the indicator light turns off, indicating that the codes have been cleared.
  2. Choose a button for programming: In the Kia Sorento, there is a panel with three buttons located on the driver’s sun visor or overhead console. Choose one of these buttons to program as the garage door opener button. For the purpose of this guide, we’ll refer to it as Button A.
  3. Enter programming mode: To enter programming mode, press and hold the desired button (Button A) on the sun visor or overhead console until the indicator light begins to blink rapidly. This indicates that the vehicle is ready to learn a new code.
  4. Activate the garage door opener’s learn mode: Locate the “learn” button on your garage door opener’s motor unit. Press and release this button to activate the opener’s learn mode. The indicator light on the motor unit should turn on, indicating that it is ready to learn a new code.
  5. Transmit the code: Within 30 seconds of activating the garage door opener’s learn mode, press and release the programmed button (Button A) in the Sorento. This transmits the code to the opener.
  6. Test the code: After transmitting the code, press the programmed button (Button A) again to test if the programming was successful. The garage door should open or close in response to the button press. If it doesn’t work, repeat steps 3 to 6, ensuring that you follow the timing instructions carefully.
  7. Program additional buttons (optional): If your garage door opener supports multiple buttons, you can program additional buttons on the sun visor or overhead console by following the same steps as above, choosing a different button (Button B or Button C) and repeating the programming process.
  8. Exit programming mode: To exit programming mode, simply wait for about 30 seconds or turn off the vehicle’s ignition.
  1. Confirm the programming: After programming the garage door opener, it’s important to confirm that the code was successfully stored. Test the garage door opener by pressing the programmed button (Button A) again. If the door opens or closes as expected, it indicates that the programming was successful.
  2. Safety sensors alignment: Some garage door openers are equipped with safety sensors that prevent the door from closing if there is an obstruction. Make sure the sensors are properly aligned and free from any obstructions. Adjust them if necessary to ensure they are facing each other and the indicator lights are solid and not blinking.
  3. Rolling code systems: If your garage door opener uses a rolling code system, where the code changes every time the door is operated, additional steps may be required. Consult your garage door opener’s manual to learn how to program a rolling code system and follow the instructions accordingly.
  4. Battery replacement: If the programmed button (Button A) stops working or becomes less responsive over time, it may be an indication that the battery in the remote transmitter needs to be replaced. Refer to the owner’s manual for instructions on how to replace the battery.
  5. Professional assistance: If you encounter difficulties or are unsure about the programming process, it is recommended to seek assistance from a professional or contact the manufacturer of your garage door opener for further guidance.

Remember to always follow safety precautions when programming the Garage Door Repair Keller TX opener. Ensure that no one is standing or walking under the garage door while programming or testing it. Additionally, make sure to keep the garage door opener remote out of reach of children.

Keller Garage & Overhead Doors

3529 Heritage Trace Pkwy#12, Keller, TX 76244

817-769-3540